The definition of candelabra is defined as a multiple group of traditional decorative candlestick holders. While this is after the case before electricity was invented, today’s interior designers have electrified the candelabra and the term now denotes a multiple group of faux decorative candlestick holders. These lighting fixtures range in dimensions and design. From three piece table top candelabras, to 20 or more piece chandelier style candelabras, hanging candelabra can be quite heavy and difficult to install. Use this guide to hanging candelabras and you’ll be sure your candelabra installation goes perfectly CLAXY.COM.

Centering the Candelabra

Center the candelabra in the midst of the room. Measure both horizontally and vertically throughout the ceiling, divide the 2 measurements by 50 percent and mark the biggest market of the space. For ceilings that are on an angle, repeat the process on the ground and produce a mark. Now work with a plumb bob to find the biggest market of the ceiling to hang the light fixture.

Locating a Joist

Because many candelabra light fixtures tend to be produced from wrought iron and are extremely heavy, they need proper support when hanging them from the ceiling. Locating a joist is imperative to installing a candelabra safely. The quickest and simplest method is to enter the attic space above the candelabra and look for a joist. Drive a nail close to joist to create a mark for reference down below.

Of course, it’s not always easy or mightn’t be possible to enter the attic space above the candelabra. In this instance, an electric stud finder can allow you to locate a joist. Measuring every 24 inches from a nail hole can offer you a cheap way to find joists. Use a small finish nail and a hammer to find the joist.

Once a joist is found, the ceiling light box can be secured onto the joist. If the joist is too much from your own center mark, you may need to put in a wooden rosette that spans along the 2 joists. This allows you to secure the candelabra light box to a strong surface.

Hanging the Candelabra

Just before hanging a lighting fixture of the size, it’s a good idea to obtain a few friends to help. Several ladders should really be secured, tested and in position before you begin. Have a couple of people on a lawn hoisting the candelabra to the a couple on the ladder. One person on the ladder should guide the holding hook onto the light box hook. Another ladder person should steady and help support the weight of the candelabra. The chain should quickly be attached, and then the candelabra can be released and wired according to the manufacturer’s specifications.

Write Your Comments

Your email address will not be published. Required fields are marked *

Archives

Categories

Meta